| Keyword TIMEDEL missing | error | |
| The keyword TIMEDEL is missing | ||
| Keyword TSTART missing | error | |
| The keyword TSTART is missing | ||
| Keyword TSTOP missing | error | |
| The keyword TSTOP is missing | ||
| Existing output file cannot be overwritten | error | |
| The output file
exists, and cannot be overwitten because the SAS_CLOBBER variable
is set to 0 | ||
| Unavailable default device type and/or output file | error | |
| Unavailable default device type and/or output file | ||
| Input file has null or negative bin width | error | |
| The keyword
TIMEDEL is zero or has a negative value. This must be a
positive value and indicates an error in the TIMEDEL value | ||
| Unavailable device type and/or output file | warning | |
| The device type
and output file are set to the defaults. In this way,
omthlcplot
can be executed
corrective action: No corrective action is required, although subsequent executions of the task should use a valid output device type | ||
| Data points to plot must not exceed 500 | warning | |
| Plotting more than 500 data
points, results in a very large output file and plots which are
overcrowded, hence the number of points are limited
corrective action: The binsize is automatically increased until the number of points to plot is lower than 500 [1] | ||
| Keywords are missing from the input file | warning | |
| Some header keywords are missing or
inconsistent. Key words expected are TSTART, TIMEDEL
and TSTOP and the values OGIP, TOTAL,
LIGHTCURVE, and RATE in the attributes HDUCLASS,
HDUCLAS1, HDUCLAS2, and HDUCLAS2 respectively
corrective action: A warning is raised and the task tries to proceed | ||
| Binning_Factor must be positive | warning | |
| The binning factor specified by the user, is less than
unity. This must be at least unity
corrective action: The binning factor is automatically set to unity. Future executions of omthlcplot should use a binning factor of at least unity | ||
