XMM-Newton SAS Home Page
XMM-Newton Science Analysis System


slconv (slconv-2.6.1) [xmmsas_20211130_0941-20.0.0]

Errors

This section documents warnings and errors generated by this task (if any). Note that warnings and errors can also be generated in the SAS infrastructure libraries, in which case they would not be documented here. Refer to the index of all errors and warnings available in the HTML version of the SAS documentation.

badOutputStyleerror 
 The value of the outputstyle parameter was not recognized.
 
badLabelSortStyleerror 
 The value of the labelsortstyle parameter was not recognized.
 
badLabelStyleerror 
 The value of the labelstyle parameter was not recognized.
 
noSourcesSelectederror 
 The selection expression passed zero sources.
 
tResultColAlreadyExistserror 
 Signals that the source list already contains a column T_RESULT.
 
indexColAlreadyExistserror 
 Signals that the source list already contains a column INDEX.
 
badRaDecUniterror 
 The value of the radecunits parameter was not recognized.
 
rResultColAlreadyExistserror 
 Signals that the source list already contains a column R_RESULT.
 
allRadiiAreNullserror 
 All the rows specified by radiusexpression are null-valued.
 
scaleBalanceErrorerror 
 The subroutine scaleBalance returned a non-zero error status.
 
lResultColAlreadyExistserror 
 Signals that the source list already contains a column L_RESULT.
 
badLabelExpressionerror 
 The task has assumed that labelexpression contains just one column name. It has not found a column of that name in the source list.
 
badRegionShapeerror 
 The region shape is not allowed
 
badLabelColDataTypeerror 
 The data type of the column specified in parameter labelexpression is not recognized.
 
badExtraGaiaColNameerror 
 One of the columns listed in extragaiacolumns was not found in the source list.
 
badExtraGaiaColDataTypeerror 
 One of the columns listed in extragaiacolumns had an unrecognized data type.
 
badOutFileStyleerror 
 The value of the outfilestyle parameter was not recognized.
 
someRadiiAreNegativewarning 
 Some of the source radii were found to be less than zero. You may need to rethink radiusexpression.
corrective action: These values will be replaced by zero.
 
someRadiiAreNullswarning 
 Some of the source radii were found to be null-valued (NaNs).
corrective action: The offending sources are not plotted.
 
allIntegerRadiiAreZerowarning 
 After conversion to integer, all of the radii were found to be equal to zero. You will need to make them bigger in radiusexpression.
corrective action: No action.
 
someIntegerRadiiAreZerowarning 
 After conversion to integer, some of the radii were found to be equal to zero. You may want to make them bigger in radiusexpression.
corrective action: No action.
 
noSourceswarning 
 No sources have passed the filtering expression.
corrective action: Program exits gracefully.
 
radiiAllEqualwarning 
 The maximum and minimum source radii are the same. This can happen in a number of ways. Maybe there is only one source; or maybe you have a constant expression in radiusexpression. In the latter case there is no point in asking for radiusstyle=`auto'.
corrective action: Task proceeds anyway.
 

XMM-Newton SOC -- 2021-11-30